|
The switchstand comes
with two brass throwbar extensions, four mounting screws and four
throwbar screws.
Referring to the
photo above, which shows the throwbar extensions removed from their
proper location,
1)
Attach the switchstand to
the headblock ties using the pilot holes provided.
2)
Screw the long throwbar
extension to the lower holes in the switchstand mechanism and the
throwbar. The predrilled holes are not threaded but made to an
interference fit for the screw. Carefully insert the screw until it is
almost snug, then back it off a ¼ turn, to allow movement between the
throwbar and extension. The interference fit will keep the screw in
place.
3)
Do the same for the short
extension in the upper holes. The switch should now be operable. |
